4. OSHA Requirements for Harnesses on Wheeled Scissor Lifts Lanyard anchor points, as originally equipped or authorized by JLG for installation on JLG products, are developed and tested by JLG. These permitted lanyard anchorages meet or exceed the static tensile test requirements of 5,000 lbs (2273 kg) specified in OSHA 1926.502, Section (d)(15) and the test criteria for lanyard anchorage points required by applicable CSA B354. Each authorized lanyard anchor point is specially designed for use by one (1) person. An authorized lanyard anchorage must be in place for each additional person on the platform. When used in accordance with the manufacturer`s instructions for use and recommendations, JLG products remain stable if a person falls off the platform while properly wearing an approved fall protection device (when the fall is limited to 6 feet or less) attached to a specific anchorage point. For JLG products intended for use with a lanyard of up to 30 inches (76 cm), a fall arrest system would prevent a person from falling off the platform. Your safety is very important to JLG. To better help you and your customers, JLG provides information on everything from inspections and manuals to Manlift safety guides and videos.

For key MEWP safety, product and training information related to JLG equipment, visit the Service Parts page. Do you want to stay up to date on industry news and similar topics? Be sure to subscribe below to receive monthly updates from Direct Access with newly released content so you don`t miss out on important information. Scissor lift seat belts remain a hotly debated topic. Our training is designed to help employees create a safe work environment for their elevator operators. That`s why we cover the following topics in our fall protection training and safety courses: There are currently no ANSI/SIA, CSA or OSHA requirements to wear fall protection on scissor lifts or vertical mast lifts (machines covered by ANSI A92.6 and A92.3 and CSA B354.2 and B354.1). Although not required by ANSI, CSA or OSHA, JLG recommends using a full body belt with a lanyard attached to an authorized lanyard anchor point when using JLG hoists or vertical masts that are not a maximum length of 30 inches (76 cm). Machines with a maximum length of 30 inches (76 cm) have a sticker next to the lanyard anchor point indicating this maximum length. A fall protection system must be used if fall protection equipment is to be used on machines up to 30 inches (76 cm) in length. The use of fall protection systems is not permitted. For certain JLG vertical masts designed to be able to open (retract) or remove the guardrail, JLG requires that appropriate fall protection equipment be used with a lanyard attached to an authorized lanyard anchor point if the guardrail is not fully positioned around the perimeter of the platform. JLG is currently manufacturing new scissor and vertical mast lifts with lanyard anchor points as standard equipment. For certain older models of JLG scissor mesh lifts and vertical mast lifters that were not originally equipped with lanyard anchor points, a JLG Authorized Dealer may install lanyard anchor points in accordance with the JLG specifications of the applicable JLG product.

These authorized lanyard anchorage points, as installed by JLG or properly installed by an authorized JLG dealer, are considered fall protection for a fall protection system. On some older models JLG wheeled scissor lifts that are not equipped with approved lanyards, the user may be attached to the centre rail section of the main platform rail. Fall protection systems prevent the occupant of a boom lift from falling. If the person is protected by a restraint system, a seat belt or a complete belt may be used. If a restraint system is used as a fall protection system in a Group B aerial work platform, the employer/user/operator must ensure that the lanyard and anchor are located in such a way that the operator is not exposed to a fall outside the platform. There are no books or other documents to buy. All courses are accessible online 24/7 with a smartphone, tablet or similar digital device. Your entire staff can complete the CMO`s fall protection training in just one hour. They know when and how to properly use scissor slings and other safety devices to prevent injuries from fall-related accidents. Our OSHA fall protection requirements training also provides: Understanding when a harness is needed on a scissor lift can help you and your colleagues stay safe at work. Of course, proper training can help create an overall safer work environment for your team. If you want to promote a culture of safety in your company, consider partnering with CertifyMeOnline.net for education and training.

Since falls are one of the leading causes of death in the construction industry, fall protection systems are usually needed in one form or another. Although OSHA requirements for wheeled scissor lifts are set to specific heights, it may be helpful to consider fall protection system requirements. OSHA says any work done more than six feet above the ground warrants the use of a fall protection system. I hope this interpretative letter from OSHA will help explain the arrest/restraint requirements and the rationale for each implementation. www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=22006 OSHA scissor lift belt requirements specify when and how elevator operators must wear a belt. The requirements also state that it is the employer`s duty to protect employees from falls and other types of workplace accidents. Employers must also train and certify their employees before they start using forklifts on the job. Failure to do so can result in costly OSHA fines and penalties.

Are you ready for your business to become OSHA compliant in just one hour? Register your employees now! If you still have questions about OSHA fall protection requirements or other CMO training, please contact us online or call us at (602) 277-0615 to speak to one of our OSHA experts who will be happy to assist you. In this blog, we will discuss the requirements for transporting fall protection devices on two of the most common aerial work platforms: raisin pickers (or aerial work platforms) and scissor lifts. If your company has gaps in MEPP operator training that need to be addressed, or if you have employees who need fall protection and scissor harness training, sign them up for CertifyMeOnline.net fall protection certification training today. Our OSHA-compliant training program offers online convenience, affordable prices, and can be completed in as little as an hour. Most importantly, you can protect your employees from falls, reduce the risk of serious injury and death, and improve productivity at work. Even if it is not specifically required, it is recommended that you always use a seat belt when working from a scissor lift to increase safety at work. For fall protection on aerial work platforms, all JLG modelsĀ® are currently manufactured with lanyard anchor points. The ANSI Standard for boom mounted aerial work platforms (A92.5) and the Canadian Standard for boom supported aerial work platforms (CSA B354.4) require all employees to wear fall protection devices on the platform at all times.

In the United States, OSHA`s Aerial Platform Regulations (CFR 1926.453(b)(2)(v)) require platform occupants to wear a body belt with a lanyard attached to the boom or basket when working from an aerial work platform. As of January 1, 1998, OSHA`s fall protection rule requires the use of a full harness for fall protection instead of a seat belt when working from an aerial work platform. The entire body belt must be attached to an anchorage point of the lanyard by means of a lanyard. Fall Protection in a Raisin Picker – OSHA Requirements Understanding OSHA belt requirements for scissor lifts doesn`t have to be difficult. It all comes down to the four elements of fall protection: fall protection, positioning, suspension and recovery. Each of these elements is covered in detail in the CMO`s fall protection course. OSHA does not require seat belts to be worn when working from scissor lifts, as long as an adequate guardrail system is in place.

Menu